 |
Heavy Duty Floor Mats
Imagine DeLorean floor mats that don’t wear out in a
couple of years and don’t bunch up under your feet!
Most replacement mats don’t fir properly because
they’re patterned after the originals which are
undersized and tend to shift around. I made a new
pattern from my own car and they are over one inch
wider in some places but will fit your car much
better than the stock mats. The backing has also
been recently upgraded to a heavy duty plastic with
nubs to hold it more firmly in place than before.
Together these improvements make these mats an
unbeatable combination of quality and value.
Black DMC Logo Floor Mats (A1000020G) $149.95
add to cart
Grey DMC Logo Floor Mats (A1000019G) $149.95
add to cart
|
|
 |
Roof and Door Headliners and Kits
These headliners are new, not reconditioned, and
that’s what sets them apart form the competition.
There are no bulky cores to deal with sending back
and they have thin fiberglass underbodies which are
moisture-proof and will last forever, unlike the
pressboard originals. Do it once and do it right!
The door headliners include mounting “fir trees” and
the roof headliners come with a brush top can of
installation adhesive and black stainless sunvisor
mounting screws.
Dark Grey Door Headliner Set(105753-4FG) $250.00
add to cart
Dark Grey Roof Headliner Set(105191-2FG) $250.00
add to cart
Dark Grey Complete Headliner Set(DGHDLNR)
Includes all four headliners, glue and “fir trees”.
$450.75
add to cart
Light Grey Door Headliner Set(110062-3FG) $250.00
add to cart
Light Grey Roof Headliner Set(110059-60FG ) $250.00
add to cart
Light Grey Complete Headliner Set(LGHDLNR)
Includes all four headliners, glue and “fir trees”.
$450.75
add to cart
|
|
 |
M.T. Shift Boot Assem. & Heavy Duty Shift Lever
This high quality leather shift boot is bonded to a stainless steel slimline
frame which keeps the boot from tearing and the frame from breaking. We’ve been
selling these for twenty years and have never had any complaints. The heavy
duty shift lever is a new item we’ve had made from T4041 steel which
is much stronger than the original mild steel shift lever. This part is
not only stronger than the original but much less expensive than buying
the entire shifter assembly to get the lever that just broke off in your hand!
Shift Boot with Stainless Frame (100688G)
Note: Boot and frame available separately.
$78.85
add to cart
T4041 M.T. Shift Lever (100688G)
Includes stronger retention pin (not shown in picture)
$95.00
add to cart
|
|
 |
Stainless Steel Fuel Tank Closeout Plate
If you ever had a brake master cylinder leak (very common after twenty years) chances are your fuel tank closeout plate is rusted.
Brake fluid lifts the original epoxy coating and is highly corrosive causing major rust problems without early detection. You
can usually spot the problem by inspecting for wrinkly and soft paint near the left front edge of the plate below the master
cylinder. Rust can spread to the frame and removing the plat and checking is the only way to confirm everything is OK. New
original plates are unavailable and many are just too far gone to refinish unless you don’t mind holes!
This stainless replacement is beautifully crafted and is a much more permanent solution for this high risk area of your frame.
Stainless F.T. Closeout Plate (101716GS)
$260.00
add to cart
Stainless Fastener Kit (FTBSSKIT)
$24.95
add to cart
|
|
 |
SS Sleeved Axle Flange and/or Crankshaft Pulley
Oil leaks are common and sometimes hard to fix on these areas of the DeLorean. These reconditioned parts are
replated and fitted with a hardened stainless steel sleeve which won’t groove or pit. The sleeve also increases
the O.D. slightly which helps particularly with the Axle seal as there is a lot of free play or movement in the
Axle flanges. The crankshaft pulley kit uses a double lip seal to further improve oil retention.
These parts help ensure you won’t have to deal with oil spots in your driveway!
Reconditioned Axle Flange Kit (110539R)
Includes sleeved flange, oil seal, o-ring and retention pin.
$99.95
Core Charge (Refundable) (110539C)
$50.00
add to cart
Reconditioned Crankshaft Pulley Kit (102469R)
Includes sleeved pulley and double lip oil seal.
$89.75
Core Charge (Refundable) (102469C)
$50.00
add to cart
All items in kits available individually including sleeve kits.
Note: Crankshaft pulley shown with in-installed sleeve and installation tool. All kits come with sleeves installed.
|
|
